Orien FS50IMOD Manuel d'utilisateur télécharger pdf (Page 9)

INSTALLATION CLEARANCES

Ice Maker Installation

Unpacking

Remove packaging materials

IMPORTANT: Do not remove any permanent instruction labels or the data label on your ice

maker.

Remove tape and glue from your ice maker before using.

•

To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue

residue can also be easily removed by rubbing a small amount of liquid dish soap over the

adhesive with your fingers. Wipe with warm water and dry.

•

Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to

remove tape or glue. These products can damage the surface of your ice maker.

Cleaning before use

After you remove all of the packaging materials, clean the inside of your ice maker before using

it. See "Interior cleaning" in the Cleaning and Maintenance section.

Location Requirements

Excessive Weight Hazard

Use two or more people to move and install ice maker.

Failure to do so can result in back or other injury.

Top View

Side View

Rear of uni t

Front of uni t

1/5"

Si de

1/5"

Si de

2/5"

Top of uni t

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 54 55

Pas de commentaire

Orien FS50IMOD Manuel d'utilisateur Page 9